Gérard à Liège，650 mm，約 1845
Gérard à Liège, 650 mm, circa 1845
A classicistic table regulator of fine qualitiy with jumping seconds, special form pin wheel escapement and half hour / hour strike - case attributed to Jean-Joseph Chapuis
Case: veneered with ebony, brass inlays, glazed on all sides, cuboidshaped base, four square columns, rising stepped top. Dial: enamel, radial Roman hours, centre seconds, signed, blued Breguet hands. Movm.: solid round pendulum movement, solid moulded movement pillars, special form pin wheel escapement with turnable click and fine adjusting device, 2 barrels for going and striking train, locking plate, 1 hammer/1 bell, compensation grid-iron pendulum with knife edge suspension.
Auguste Gérard (or Antoine-Joseph Gérard) was born in Namur in 1813; he began his apprenticeship in Namur in 1830 and continued it from 1832 on with the maker Mathieu Cleinge in Liège. He trained with Ratel in Paris from 1835 to 1837 and eventually established himself at Place Saint-Lambert in Liège. He died there on October 9, 1891.
Source: Florent Pholien, L'horlogerie et ses artistes au Pays de Liége, Editions nationales Liège, 1933, p. 90
Jean-Joseph Chapuis (1765-1864) was one of the most important cabinet makers in Brussels during the late 18th and early 19th century.
Jean-Joseph Chapuis (1765-1864) was one of the most important cabinetmakers at Brussels at the end of the 18th and the beginning of the 19th century.
机蕊 非常好, 走動正常
机蕊 非常好, 走動正常